LUMATEK 250W 240V DIGITAL BALLAST

High performance with low power consumption and operating cost make the LUMATEK Digital Ballast 250W a great ballast for beginner and professional growers of light-sensitive crops.

A ballast is necessary to light high intensity discharge (HID) lamps such as high pressure sodium (HPS) and metal halide (MH) grow lamps. Depending on the type of crop and light cycle required, ballasts run continuously 8 – 24 hours a day and must therefore be as efficient as possible. With less energy wasted as by-product heat Lumatek ballasts create more light from less energy consumed.

Conventional core & coil magnetic ballasts waste a large proportion of the energy consumed as by-product heat, can experience a reduction in performance over time and can even catch fire through extended use.

Lumatek digital ballasts control start phases and voltage output via microprocessors which improve lamp performance and less energy is wasted as heat. Even in long term operation the LUMATEK 250W Digital Ballast will only become lukewarm and has full circuit protection including open/short circuit, over temperature, over/low voltage, end of lamp life/rectification and EMI suppression.

Selecting the Super Lumens (SL) switch setting on Lumatek ballasts boosts power output to HPS lamps by 10% increasing luminosity and PAR/PPF levels. We do not recommend dimming or boosting MH lamps which should be matched with the same power setting (eg. 250W lamp at 250W and 150W lamp at 150W setting).

Lumatek ballasts are supplied complete with fixed-cable connectors ready for immediate use ‘plug & play’.

Product Code: LUMB0001

Voltage: 240V 50/60Hz
Input Current Max (A): 1.20A
Input Power: 265W
Output power: 250W
Power factor: >0.99
Voltage range: 175 to 275V
THD: <8%
Lamp CCF: <1.7
Operating frequency: high frequency
Envirement temperature for full load operation: -25 to 50°C (-13 to 122°F)
Enclosure temperature rise: (Δt) 25 °C (77 °F)
Environment IP require: >IP23
Humidity: capable of operating in relative humidity of 0% to 90%,non-condensing.
Dimensions: 200 x 114 x 81mm
Weight: 2Kg

Electronic ballast for 150W,175W or 250W HPS or MH lamp
No audible noise, no flicker
Full circuit protection; open/short, over temperature, over/low voltage, end of lamp life/rectification
EMI suppression certified

To light a 150W lamp; set control to 150W.
To light a 175W lamp; set control to 175W or dim to 150W.
To light a 250W lamp; set control to 250w and boost output by 10% by switching to 'Super Lumens' or dim down to 175W or 150W.

Request information about this product:

Country *:
Inquiry Type *: PrivateBusiness Owner


Check out our FAQ page, or reach us by e-mail:

For sales support:
orders@lumatek.co.uk

For technical support:
techsupport@lumatek.co.uk